Pages

June 07, 2013

Fins for American Girl Doll

See my other beach item tutorials 

 

What you need

  • flexible cutting board (got mine at Walmart, came in a set with 3 different colors)
  • duck tape, color of your choice

How to make the fins

1. Download free pattern here
    Remember to set page scaling to none.
    For Home use only, this is copyrighted by me, Read Creations !!!!

2. Cut out the right and left fine from flexible cutting board.

3. Optional, cut one of the soles from cutting board, this will make cutting the soles from duct
    tape a lot easier
    (you can flip it over to use for the other foot)

4. Fold flaps flaps up, following the side line of the fins. I used a ruler to get a straight fold

5. Take a piece of duck tape, align along the fold and tape on the inside of the flaps and cut
    around.
    Repeat for other side.

6. Take template from step 3 and tape with one piece of duck tape and cut out template.
    This should give you a nice cut.

7. Peal duck tape sole off template and tape on the inside of fin
    (make sure you have the correct foot)


8. Fold up flaps and overlay slightly and tape on the inside with a scrap duck tape piece


9. Take a big duck tape piece and cover the whole top. Make sure your seam on top is flat.

10. Cut duck tape level with sole and cut the top to be about 1/4" longer than flap. 
      Cut slits up to the flap and fold towards flap

11.  Repeat steps 4 - 10 for other fin.

12. Cut a 3 3/4" piece of duck tape and cut in half lengthwise

13. On one of the strips fold up one third, then fold down the top to form a strap.
      Repeat for other strap.

14.  Take a little scrap piece of duck tape and tape both ends of strap to fin.
       Repeat for other fin.
 


14. Now you could add more decoration if you want




 You are done !!!

Return to see other beach items. 

6 comments:

  1. Wow that is awesome, I have never seen a tutorial for these! :D

    ReplyDelete
  2. that was my problem too, that's why I wrote it. I am still trying to figure out how to make a mask that is sturdy enough. Snorkel tutorial is coming soon

    ReplyDelete
  3. AFTER SEEING THE FINS I ATTEMPTED A MASK. I USED AN EMPTY CRYSTAL LIGHT
    CONTAINER. THEY HAVE AN OVAL SHAPE. I USED THE LID TO MAKE THE MASK PART, I CUT OUT THE CENTER LEAVING A LITTLE AROUND THE EDGE TO HAVE SOMETHING TO GLUE A CLEAR PIECE OF PLASTIC. I CUT ABOUT AN INCH OR SO FROM THE TOP OF THE CONTAINER AND TRIMMED THE TOP AND BOTTOM TO CURVE IN FOR THE FOREHEAD AND NOSE ARE. I COVERED THE SIDE OF THE MASK WITH DUCT TAPE AND CUT A PIECE FOR SCRAPBOOK PAPER THAT MATCHED THE TAPE TO PUT ON THE MASK PART. I AM GOING TWO SLITS IN THE SIDE FOR ELASTIC FOR THE STRAP. I HAVE SOME STORE BRAND CONTAINERS THAT HAVE NOT QUITE AN OVAL SHAPE BUT WILL ALSO WORK. LOVE YOUR IDEAS.

    ReplyDelete